Starting Cold Engine - Echo Power Pruner PPT-300ES Operator's Manual

18

startIng cold engIne

WARNING
The attachment should not move at idle, otherwise serious personal
injury may result.
1. Stop Switch
Move stop switch button (A) forward away from the STOP
position.
2. Choke
Move choke (B) to "Cold Start" (
3. Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
WARNING
Inspect starting area for hazards such as rocks, glass, debris etc.
which could be contacted by the cutting attachment when starting.
Keep helpers and bystanders at least 15 m (50 ft.) from starting
area, otherwise serious personal injury may result.
4. Recoil Starter
Lay the unit on a flat, clear area, and keep movable attachment
parts clear of all obstacles. Firmly grasp throttle handle with left
hand. Do not depress throttle trigger. Rapidly pull recoil starter
handle/rope (D) until engine fires (or maximum five [5] pulls).
5. Choke
After engine fires (or five [5] pulls), move choke lever back to
"Run" ( ) position. Pull recoil starter handle/rope until engine
starts and runs. Allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in "Run" position after 5 pulls,
repeat instructions 2 - 5.
6. After engine warms up, gradually depress throttle trigger to in-
crease engine RPM to operating speed.
) Position.
A
B
C
D
D