Lubricating The Guide Bar And Saw Chain; Adjusting Automatic Oiler - Echo Power Pruner PPT-300ES Operator's Manual

lubrIcatIng the guIde bar and saw chaIn

Automatic Oiling System
1. Wipe debris from around oil fill cap.
2. Remove oil fill cap and fill reservoir with a quality, low viscosity
guide bar and saw chain oil.
IMPORTANT
To prevent plastic deterioration, do not use synthetic or silicone
based oil.

adjustIng automatIc oIler

1. From bottom of gear case, turn adjustment screw (A) clockwise to
decrease oil volume - counter clockwise to increase oil volume.
NOTE
The automatic oiler is preset to deliver a sufficient oil discharge
volume during normal operating conditions. During heavy or dry
cutting conditions, the oil discharge volume may be increased to as-
sure adequate lubrication. If oil is leaking from the bar cover area,
reduce the oil discharge volume. Refill the oil reservoir with each
tank of fuel.
NOTE
Very little visible oil on the saw chain will provide sufficient lubri-
cation.
P P
ower
o '
PeraTor s
A
TM
runer
17
M
anual