Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL GE-DP 6935 A ECO Original Operating Instructions

Application 2:
The pump can be used in autostart mode for ri-
sing water levels. When the preset autostart level
is reached, the pump starts automatically. Re-
gardless of the selected autostart level, the pump
will pump until 70 mm is left and will then continue
running on for a further 15 seconds before swit-
ching off automatically.
Please note:
The fact that it switches off automatically after
15 seconds prevents the pump from running dry
for any prolonged period of time. Since the pump
continues running, a low amount of noise may be
generated if there is no liquid, but this will not lead
to any damage to the pump. The water can be su-
cked up down to a level of 40 mm as a maximum.
Application 3:
The pump can be used in autostart mode where
the water level at the beginning is higher than the
preset autostart level. Regardless of the selected
autostart level, the pump will pump until 70 mm is
left and will then continue running on for a further
15 seconds before switching off automatically.
Please note:
The fact that it switches off automatically after
15 seconds prevents the pump from running dry
for any prolonged period of time. Since the pump
continues running, a low amount of noise may be
generated if there is no liquid, but this will not lead
to any damage to the pump. The water can be su-
cked up down to a level of 40 mm as a maximum.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_GE-DP_6935_A ECO_7935_N-A_ECO_SPK7.indb 18 Anl_GE-DP_6935_A ECO_7935_N-A_ECO_SPK7.indb 18
GB
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Cleaning the paddle wheel (Fig. 1/Item 3)
If a lot of deposits collect in the housing, the bot-
tom part of the equipment must be dismantled as
follows:
1. Disconnect the intake cage from the housing.
2. Clean the paddle wheel with clear water.
Caution! Do not put down or rest the equip-
ment on the paddle wheel!
3. Assemble in reverse order.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 18 -
05.07.2023 13:58:21 05.07.2023 13:58:21