Asus P5LD2-VM/CR Manual page 39

5. Digital Audio connector (4-1 pin SPDIF_OUT) (optional)
This connector is for the S/PDIF audio module to allow digital sound output.
Connect one end of the S/PDIF audio cable to this connector and the other
end to the S/PDIF module.
P5LD2-VM/CR Digital audio connector
The S/PDIF module is purchased separately.
6. ATX power connectors
(24-pin EATXPWR and 4-pin ATX12V)
These connectors are for ATX power supply plugs. The power supply plugs
are designed to fit these connectors in only one orientation. Find the proper
orientation and push down firmly until the connectors completely fit.
• Do not forget to connect the 4-pin ATX +12 V power plug; otherwise, the
system will not boot.
• Use of a PSU with a higher power output is recommended when
configuring a system with more power-consuming devices. The system
may become unstable or may not boot up if the power is inadequate.
• Make sure that your power supply unit (PSU) can provide at least the
minimum power required by your system. See the table below for details.
P5LD2-VM/CR ATX power connectors
ASUS PLD2-VM/CR
SPDIF_OUT
GND
SPDIFOUT
+5V
ATX12V
+12V DC GND
+3 Volts
+12 Volts
+12 Volts
+5V Standby
+12V DC GND
Power OK
Ground
+5 Volts
Ground
+5 Volts
Ground
+3 Volts
+3 Volts
EATXPWR
Ground
+5 Volts
+5 Volts
+5 Volts
-5 Volts
Ground
Ground
Ground
PSON#
Ground
-12 Volts
+3 Volts
1-2