NOTE: If you select Yes for either of the features mentioned above, the
message will not appear the next time you intend to change the
settings of these features. When you perform a factory reset, the
message will appear again.
When the monitor goes into Standby mode, the following message appears:
Activate the computer and wake up the monitor to gain access to the OSD.
You will see the following message before the Lock function is activated:
NOTE: The message may be slightly different according to the selected
settings.
The OSD functions only in the normal operation mode. If you press the joystick
during the Standby mode, the following message will appear depending on the
selected input:
Activate the computer and the monitor to gain access to the OSD.
NOTE: The message may be slightly different according to the
connected input signal.
│
72
Operating the monitor