Brother HL-L5218DN Quick Setup Manual

CHN-ENG
Version 0
EN
Unpack the machine and check the components
Toner Cartridge and Drum Unit
USB Interface Cable
1
Remove the packing materials and re-install the toner cartridge and drum unit assembly
2
Load paper in the paper tray
3
Connect the power cord and turn the machine on
Back
Quick Setup Guide
HL-L5218DN / HL-L5228DW / HL-L6418DW
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct installation procedure.
Operation Videos:
www.95105369.com
Assembly
(Installed in the machine)
Quick Setup Guide
Discard the silica
gel pack.
Adjust the paper
guides.
Power button location may vary depending
on the model.
Front
Installation & Using Videos
NOTE:
• The available connection interfaces vary depending on the model.
AC Power Cord
USB Port Cover
(Not included in all models)
• The illustrations in this Quick Setup Guide show the HL-L6418DW.
Product Safety Guide
Do not exceed this mark.
You must purchase the correct interface cable if you require one.
• USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more
than 2 metres long.
• Network cable
Use a straight-through Category 5 (or greater) twisted-pair cable.
(Network cable is not a standard accessory.)
Remove the orange part.
1