Installation Notes; Installation Requirements; Electrical Connection - Miele PDR 511 SL HP Installations Plan

Installation requirements

 Risk of injury or damage to property due to improper installa-
tion.
Incorrect installation of the tumble dryer can lead to personal injury
or damage to property.
The tumble dryer must only be installed and commissioned by
Miele Customer Service Department or an authorised dealer.

The tumble dryer must be installed in accordance with all relevant
regulations and standards.

The dryer must only be operated in a room that has sufficient vent-
ilation and which is frost-free.

The tumble dryer must not be installed behind a closeable door or
a sliding door. The maximum opening angle of the tumble dryer door
must not be limited by objects or doors. It must be possible to fully
open the tumble dryer door at any time.

Electrical connection

The electrical connection must be established by a qualified electri-
cian.

The electrical connection may only be made to an electrical system
provided in accordance with all appropriate local and national legisla-
tion, regulations and guidelines. Please also observe the regulations
set out by your insurance provider and energy supplier, accident pre-
vention regulations, as well as recognised codes of practice.

Reliable and safe operation of this tumble dryer is only ensured if it
has been connected to the mains electricity supply.
The required supply voltage, power rating and fuse rating can be
found on the data plate on the tumble dryer. Ensure that the supply
voltage matches the voltage quoted on the data plate before estab-
lishing the electrical connection to the tumble dryer.
Connection to a supply voltage other than the one quoted on the
data plate can damage the tumble dryer if the voltage is too high.

If more than one voltage is specified on the data plate, the tumble
dryer can be converted for connection to the relevant input voltage.
This conversion must be performed by the Miele Customer Service
Department or by an authorised dealer. During the conversion, the
wiring instructions given on the wiring diagram must be followed.
Tip: It is recommended to connect the tumble dryer using a suitably
rated plug and socket connection in accordance with IEC 60309-1, or
if a hard wire connection is required then an all-pole isolation device
must be available at the site of installation.
en - Installation notes
13