Table of Contents
Advertisement
Precautions When Using Discs
GB
Handle your discs with care. Always hold them by the edges to
avoid leaving fingerprints on the shiny surface.
When you have finished playing a disc, always put it back in its
case.
Do not fix paper or adhesive tape to the discs and do not write on
the label.
Clean them with a special-purpose cloth.
Store your discs in a clean place, out of direct sunlight, where they
will not be exposed to high temperatures.
Precautions When Using Audio
Cassettes
Check that the tape in the cassette is sufficiently taught.
To prevent erasing a cassette that you wish to keep, remove the
safety tab on the upper edge of the cassette. To record a cassette,
where the tab has been broken, simply cover the opening with
adhesive tape.
When you have finished playing a cassette, always put it back in its
case.
Store your cassettes in a clean place, out of direct sunlight, where
they will not be exposed to high temperatures.
Avoid using 120-minute cassettes as they place unnecessary strain
on the tape mechanism.
33
Trouble Shooting Guide
It always takes a little time to become familiar with a new appliance.
If you have any of the problems listed below, try the solutions given.
Problem
The system does not work
• The main lead is not correctly plugged into a
• The remote control batteries need replacing
• The Standby/On button has not been
G
There is no sound
• The volume has been completely turned
E
N
• The correct function (TUNER, DVD/CD,
E
R
• You have connected a set of earphones.
A
• The loudspeaker wires have been
L
• The MUTE button has been pressed.
The Timer does not work
• The timer has been stopped by pressing
In case it does not work, even the
• Press the P. Surround button for 5 seconds in
action is taken as above.
• The DVD/CD function has not been selected.
The disc player does not start
• The disc has been inserted face down or is
playing
• The laser sensor is dirty or dusty.
• The system has not been installed on a flat,
D
V
• Condensation has formed in the player; leave
D
/
C
D
When playing a DTS, DVD disc,
• Since this product incorporates technology,
no sound is produced.
• To listen to DTS sound, connect an amplifier
The tape does not start playing
• The TAPE function has not been selected.
C
• The cassette has not been inserted correctly.
A
S
• The cassette player has not been closed.
S
• The tape is either slack or broken.
E
T
The volume falls off
• The audio heads are dirty.
T
The cassette is not erased correctly
• The rollers or drive capstans are dirty.
E
S
There is excessive wow and flutter
• The tape is worn.
Reception is poor or no radio sta-
• The TUNER function has not been selected.
tions are received at all
• The radio frequency has not been correctly
R
A
• The aerial has been disconnected or is not
D
I
O
• You are in a building that blocks radio waves;
Checks/Explanation
wall socket or the wall socket is not switched
on.
or the polarity has not been respected.
pressed.
down.
TAPE, AUX) has not been selected.
disconnected.
Timer On/Off.
power 'OFF'(standby), then it is returned the
original position (RESET)
either dirty or scratched.
horizontal surface.
the system in a warm, airy room for at least
one hour.
no sound will be output directly from the main
unit.
equipped with a DTS decoder to the digital
output (OPTICAL OUT).
selected.
facing the right way. Turn it until you find the
best orientation.
you must use an outside aerial.
Advertisement
Table of Contents
