Demo/Dimmer Function; Setting The Clock - Hyundai MX-KDZ100 Instruction Manual

Demo/Dimmer function

GB
All functions available on the system can be viewed on the
display and the display's brightness can be switched between
"on" and "off".
1
Press the Demo/Dimmer button.
Result: All functions available on the system appear on the front
panel display.
Each of these are explained in detail in this guide.
Please refer to the relevant section.
2
Press the Demo/Dimmer button again.
Result: The Dimmer function is selected and the display darkens.
3
Press the Demo/Dimmer button once again to brighten the front
panel display.
A display brightness control can only be performed while the
system power is on.

Setting the Clock

Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set the
clock:
When you first purchase the Mini Component System
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
1
Switch the system on by pressing Standby/On button.
2
Press the Timer/Clock button twice.
Result: CLOCK is displayed.
3
Press the Enter button.
Result: The hour flashes.
4
To...
Increase the hours
Decrease the hours
5
When the correct hour is displayed, press the Enter button.
Result: The minutes flash.
6
To...
Increase the minutes
Decrease the minutes
7
When the correct time is displayed, press the Enter button.
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing Timer/Clock button once.
You can also use buttons to instead Multi Jog knob
in step 4, 6.
Turn the Multi Jog knob to the...
Right
Left
Turn the Multi Jog knob to the...
Right
Left
12
GB