Table of Contents
Advertisement
Available languages
Available languages
OPERATING THE RECEIVER
1. Installation
This menu consists of 4 sub-menus:
Signal Status, Manual scanning, Auto scanning, and Reset to
Factory Default.
●
Select "Installation" in the main menu mode to
select the sub menu.
●
Enter the PIN Code.
If you have not entered your own PIN Code then the
PIN Code 0000 applies, which was set at the factory.
1.1 Signal Status
You can see the signal status for broadcasting channel you want.
●
Select the channel with Numerical (0 ~ 9) or
You can select the channel from 1 to 69.
●
Current and max. signal appear on the screen.
N N o o t t e e
: The level indicated in the "Signal Status" is only for
reference.
The signal quality may be adequate even though the level
indicated is not maximum.
●
Current and max. signal appear on the bottom of the window.
GB-18
/
keys.
D
I
G
I
T
A
L
T
E
1.2 Manual Scanning
To tune-in new channels and weak signals, the STB has
been provided with the option "Manual Scanning" where
the channel data can be entered by the user.
●
Select the target Broadcasting channel for manual scanning.
●
After select option, press OK key to start the scan process.
1.3 Auto Scanning
The sub menu "Auto Scanning" will enable download the
channels automatically.
To download channels automatically:
●
Press OK key.
Auto Scanning menu will be displayed.
You should press OK key to store all channels into STB.
1.4 Reset to Factory Defaults
This to restore the factory set values in case the user has
encountered some problems after changing any values of
channel data and others which may be in error.
At the request window, if you press the OK key, the receiver
will be reset to factory default settings automatically.
N N o o t t e e
: This cause your previous settings to be deleted!
R
R
E
S
T
R
I
A
L
R
E
C
E
I
OPERATING THE RECEIVER
V
E
R
GB-19
Advertisement
Chapters
Table of Contents
