Advertisement
Quick Links
Mounts by
A division of David Engineering & Mfg. Inc.
M odel
PDM 625T PANEL DISPLAY MOUNT
Thank you for purchasing the PDR panel display wall mount.
To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference.
All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship.
We are not liable for improper installation that results in damage to mounts, adapters or presentation equipment.
Special techniques are necessary for installation of the panel display mount.
Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the mounting
unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and airflow.
To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the
weight of both the display and the mount.
Always use at least two persons for all installations.
Fully tighten all of the mounting screws as specified in the installation instructions.
Low profile 2 5/8"
16", 24" or 32" stud mounting
Easy installation
Flat to 13 deg tilt
Lateral movement from center for better viewing position
1
Features
Advertisement
Related Manuals for David Engineering & Mfg PDR Mounts PDM 625T
Summary of Contents for David Engineering & Mfg PDR Mounts PDM 625T
- Page 1 Mounts by A division of David Engineering & Mfg. Inc. M odel PDM 625T PANEL DISPLAY MOUNT Thank you for purchasing the PDR panel display wall mount. To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference. All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship.
-
Page 2: Installation Location
INSTALLATION LOCATION WARNING The wall where the wall mount is to be installed must be capable of long-term support of the total load of the panel display and wall mount. Measures should al so be taken to ensure sufficient strength to withstand the force of earthquakes, vi bration and other external forces. - Page 3 Product specification 33.35” (847mm)max 1.65” (42mm) min 25.50” 24.61” (625mm) 36” 2.64”...
-
Page 4: Parts List
PARTS LIST Display bracket ..2 pcs Wall mount bracket…1 pc 36” Locking bar... 2 pc 5/16” Flat washers...6 pcs Plastic spacer 3/4 x 1”...4 pcs 5/16’ x 2 ½”Lag bolts...6 pcs Multi mount washer ...4 pcs 5mm x 40mm... 4 pcs 5mm x 16mm...4 pcs 6mm x 40mm...4pcs 6mm x 16mm...4 pcs... - Page 5 1. FASTEN MOUNTING PLATE TO WALL The bracket must be secured to the wall studs capable of at least (4) times the weight of the unit. The wall bracket should be mounted at the same horizontal center line as the display center line ( viewing horizontal center line). Using the four lag bolts ( E ) and washers supplied ( D ), level and secure the mounting plate to the center of .
- Page 6 3. MOUNT THE DISPLAY TO THE WALL MOUNT BRACKET Lift the display, with the brackets attached, onto the wall plate. See Fig 4 Position the top and bottom into the slots. See Fig 5 and 6 Make sure the display brackets engage the rails on the wall mount bracket (B) See Fig 5 Insert the locking bar (C) as shown in Fig 5 with the locking holes facing up to match the holes in the wall mount bracket (B) .