David Engineering & Mfg PDR UCMM50 Instructions

Under cabinet monitor mount

Download this manual

Mounts by

A division of David Engineering & Mfg. Inc.

Model

UCMM50 UNDER CABINET MONITOR MOUNT

Thank you for purchasing the PDR monitor mount with the exclusive "Bayonet locking system"

To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place

All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship. We are not liable

for improper installation that results in damage to mounts, adapters or presentation equipment.

Special techniques are necessary for installation of the panel display mount.

Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.

To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to

withstand the weight of both the monitor and the mount.

Fully tighten all of the mounting screws as specified in the instructions.

Features

Suitable for displays with 75mm &

100mm VESA mounting pattern

Simple to adjust no tools required

2"Adjustable height from 6.8" to 8.8"

100 deg tilt and 360 deg. rotation

Quick monitor removal with exclusive

"Bayonet locking system"

Mounting plate

Quick disconnect lever

View angle adjuster

Height adjuster

for future reference.

Mounting hardware

Wood screw

Monitor mounting screw

360 deg Rotation

Projector wall mounting application fig 2

Page 1 Mounts by A division of David Engineering & Mfg. Inc. Model UCMM50 UNDER CABINET MONITOR MOUNT Thank you for purchasing the PDR monitor mount with the exclusive “Bayonet locking system” To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference.
Page 2 INSTALLATION LOCATION WARNING The cabinet where the mount is to be installed must be capable of long-term support of the total load of the monitor and mount. Measures should be taken to ensure sufficient strength to withstand the force of earthquakes , vibrations and other external forces. Note: Incorrect installation can cause the projector mount to fall and cause injury.
Page 3 1 FASTENING THE MOUNTING PLATE TO THE CABINET BOTTOM Using the 4 wood screws supplied, attach the mounting bracket to the underside of the cabinet. Place the narrow end of the plate up against the cabinet front lip. A spacer and longer screws may be required if the lip is deeper than 2”.
Page 4 3. MOUNT THE MONITOR ASSEMBLY TO THE CABINET Place the monitor assembly into the bayonet slots on the mount ( small end into large end) and slide forward until the safety lever engages fig 6. Adjust the tri knobs for monitor height and angle for best viewing. To remove, lift the quick disconnect lever and slide the unit backwards and out.