Advertisement
Quick Links
Mounts by
A division of David Engineering & Mfg. Inc.
M odel
DOUBLE POLE MOUNT DPM-100
Thank you for purchasing the PDR product
To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference.
All PDR mounts and adapters carry a limited lifetime warranty from ship date against defects in material and workmanship.
Check the PDR website for details @ www.PDRmounts.com. We are not liable for improper installation that results in damage
to mounts, adapters or presentation equipment.
Special techniques are necessary for installation of the panel display mount.
Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the panel
displays and the mount.
Always use at least two persons for all installations.
Fully tighten all of the mounting screws as specified in the installation instructions.
MODEL DPM-100
Features
Suitable for Vesa 100mm and 75mm or any PDR mount
Mounts to standard 1 ½" pipe (not supplied)
Display Mount hardware included
Swivels 360 degrees
Tilts down 30 degrees
Supports two displays back to back
500 lb load capacity
Heavy metal construction
Made in the USA
1
Advertisement
Related Manuals for David Engineering & Mfg PDR DPM-100
Summary of Contents for David Engineering & Mfg PDR DPM-100
- Page 1 Mounts by A division of David Engineering & Mfg. Inc. M odel DOUBLE POLE MOUNT DPM-100 Thank you for purchasing the PDR product To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference. All PDR mounts and adapters carry a limited lifetime warranty from ship date against defects in material and workmanship.
-
Page 2: Installation Location
INSTALLATION LOCATION WARNING The ceiling where the mount is to be installed must be capable of long-term support of the total load of the panel displays and DPM-100 mount. Measures should also be taken to ensure sufficient strength to withstand the force of earthquakes, vi bration and other external forces. - Page 3 MODEL DPM-100 SPECIFICATIONS Fig1 9.560 6.290 TOP VIEW 100mm 75mm 30° MAX TILT 30° MAX TILT 100mm 6.750 75mm .265 DIA .325 DIA LOCKING SCREW SIDE VIEW FRONT VIEW MOUNTING PATTERN bottom screw BOTTOM VIEW 1 ½”NPT...
- Page 4 INSTLATION GUIDE 1: Install the DPM 100 onto the end of a threaded 1 ½” NPT (sold separably). See fig 2 2: Using the side locking screw, secure the pipe to the mount. See fig 3 3: To rotate the DPM100, loosen the bottom screws. See fig 1 Rotate to the desired viewing position and tighten the screws.
- Page 5 USING THE LOCKING TABS When using a cpm100,spm100 or dpm100 it is advised to use the locking tabs instead of the locking bar. The locking tab will keep the display from accidently moving from side to side. SEE FIG below Insert the tab into the slot on the display arm.
- Page 6 This page intentionally left blank...
- Page 7 This page intentionally left blank...
- Page 8 This page intentionally left blank...