Table of Contents
Advertisement
6.
Maintenance
6.1. Change of the tensioning wheel
Loosen the 3 fastening screws (10) and
remove the bearing plate (9). The
tensioning wheel (42/55) can be
accessed and removed from the
transport shaft.
Mounting in reverse order.
6.2. Setting the clearance
After the installation of the new
tensioning wheel (42/55) the clearance
between wheel and guide plate (40)
must be checked and, if required,
readjusted.
Setting is performed by means of the
setting screw (38). For that purpose,
loosen the counternut (39).
The clearance between the tensioning
wheel and the guide plate should
be 0,2 mm.
6.3. Cleaning and maintenance
Dirt and abrasion impair the function of the units.
Therefore, all units should be air-cleaned with compressed air in the area of the strap
guidance, notching cutters, tensioning wheel and joints after being used und, following
that, be wetted with resin-free thin spray oil.
Tool inspection!
Perform a daily visual inspection of the outside of the unit. The early detection of
damaged parts extends the life of the unit. Replace all damaged parts immediately
with Original TITAN spare parts.
PR33/DPZ-L
H365 EU 24/12
Advertisement
Table of Contents
