Table of Contents
Advertisement
LOWERING A VEHICLE
1. Turn the release valve clockwise to close it.
2. Pump the handle to raise the vehicle off the jack stands.
3. Remove the jack stands from beneath the vehicle.
4. Turn the release valve slowly counter-clockwise to lower the vehicle to the ground.
NOTE: When the jack is not in use, ALWAYS leave the saddle and ram fully retracted.
CAUTION: Keep hands and feet away from the hinge mechanism of the jack
IMPORTANT: Only fully qualified personnel should attempt maintenance or repair.
MAINTENANCE
MONTHLY MAINTENANCE
Lubrication is critical to jacks, since they support heavy loads. Any restriction due to dirt
or rust can cause slow jack movement or extremely rapid jerks, causing damage to the
internal components. To keep the jack well lubricated, carry out the following steps.
1. Lubricate the linkages, the saddle, and pump mechanism with light oil.
Linkage (1)
Linkage (2)
Roller Pin (right)
Roller Pin (left)
Lifting Arm
2. Grease the wheel bearing and axles.
3. Keep all jack surfaces and warning labels clean.
4. Check the pump for any signs of rust or corrosion. Clean the pump as required.
5
Advertisement
Table of Contents
