Operation - Jocel JSBS014634 Instruction Manual

ADJUSTABLE PLASTIC FEET
• When the Side by Side stays in the packing box, plastic feet are in tightened state. After carrying
it out from the packing box for placement, please make sure to adjust two front plastic feet until
the height is suitable; just adjust two plastic feet with a wrench or directly by hand.
• Plastic feet and rear rollers must touch the ground to prevent the Side by Side from movement,
vibration or noise. When moving the Side by Side, adjust plastic feet counterclockwise to keep
them off the ground, and then push the Side by Side gently to move it.
DOOR RACK
• Disassembly: Hold both sides of the door rack with both hands. Push it from the side without the
guide and push it inward as seen in the diagram. Push until the edge of the door rack is separated
from the grove of the liner.
• Installation: Hold both sides of the door rack with both hands. Install the buckle of the guide side
at first. Then push the other side inward slightly, the guide will then click into place and the door
rack will be installed. Please make sure it is installed properly before use.

OPERATION

BEFORE USE
This Side by Side appliance is not intended to be used as a built-in appliance.
• Remove all of the packaging, including the foam backing at the bottom of the unit and the tape
that fixes the shelves and door bins inside.
• Place the Side by Side to a proper position, and adjust the feet to level. It is recommended to
wipe out your unit with a warm soapy cloth and dry it thoroughly before use.
• Place the Side by Side and adjust to level, clean it, let the Side by Side stand for above 4-6
hours, and then power the unit on. This helps make sure that the oil from the compressor has
settled properly, and will help your unit run normally.
STARTING
• Connect the power cord, and turn on the power switch.
• Upon startup for the first time, the screen will display respective set temperature values (the
temperature of the fridge section is set to 5°C, the temperature of the freezer is set to-18°C).
• The default mode is energy saving upon startup: The screen displays for 20s and then goes off.
This mode to save energy and prolong the service life of LED lights.
54