Installation - Black & Decker Price Pfister Marielle 532 Series Manual

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238)
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price
Pfister recommends calling a professional if you are uncertain about installing
this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are
usually found under the sink or near the water meter. If you are replacing an
existing faucet, remove the old faucet from the sink and clean the sink surface
thoroughly.
3
3 TOOLS RECOMMENDED
•Plumber's putty •Slotted screwdriver
•Pliers •Adjustable wrench
•Cloth
Your installation may require new supply lines and / or shut-off valves or other
additional tools.

INSTALLATION

4 These instructions cover two different installations:
For 3-hole installation using deck plate:
For 1-hole installation using single post:
WARNING: Do not install the faucet using both the single post
mounting ring and the deck plate!
•Philips head screwdriver
•Flashlight
Go To Step 5
Go To Step 8
ENGLISH
3-HOLE INSTALLATION USING DECK PLATE
5
BOTTOM GROOVE
5 INSTALLING DECK PLATE
Ensure that Plastic Putty Plate ( 5A ) is pressed on to Deck Plate ( 5B ). Place a
bead of plumber's putty in the bottom groove along the outer edge of the Putty
Plate ( 5A ). Install Deck Plate ( 5B ) over the three holes in your sink.
6
6 SECURING DECK PLATE
From underneath sink, hand tighten Wing Nuts ( 6A ). Caution: do not over-
tighten wing nuts. Remove any excess putty from around the outside edge of
Deck Plate ( 6B ).
7
7B
7E
7 BODY INSTALLATION
Retract Pullout Hose ( 7A ) up through Faucet Body ( 7B ), until the pullout hose
fitting is flush with the bottom of Mounting Shank ( 7C ). Insert Faucet Supply
Tubes ( 7D ) and Mounting Shank ( 7C ) through the hole in Deck Plate ( 7E ). Note:
Tabs (7F) on Faucet Body ( 7B ) must be aligned with Grooves (7G) inside Deck
Plate ( 7E ). To ensure this is the case, rotate Faucet Body ( 7B ) back and forth.
When the tabs are aligned, the faucet will not rotate.
Note: Do not feed the pullout Hose (7A) back down through the spout yet.
2
5A
6B
6A
6A
7A
7B
7F
7C
7G
7E
STOP
Go To Step 10
5B
7D