Download Print this page

Olympia BS-506/WL Manual

Wireless interconnect battery operated smoke alarm

Advertisement

Quick Links

Overview of Test Key Combinations
Short
Long
Operations
Press
Press
TEST SMOKE ALARM
1
-
(LOCAL)
TEST OF ALL SMOKE ALARMS
-
1
(REMOTE)
HUSH SMOKE ALARM
-
1
(LOCAL)
HUSH OF ALL SMOKE ALARMS
-
1
(REMOTE)
BATTERY STATUTS
-
2
CHECK
SIGNAL STRENGTH
1
1
TEST
NETWORK INSTALLATION
2
1
(CENTRAL)
NETWORK INSTALLATION
-
3
(PERIPHERAL)
Indications Overview
Visual Indication
Modes
Audio Signal
(flashing)
1 Red
NORMAL OPERATION
Per Minute
1 Red
FUNCTION CHECK
Alarm Pattern
Per Second
1 Red
Alarm Pattern
ALARM
Per Second
1 Red
HUSH
Per 10 Seconds
ALARM
3 Yellow
MEMORY
Per 43 Seconds
1 short sound
LOW
None
BATTERY
every minute
3 short sounds
FAULT
None
every minute
WARNING
Battery and Wireless Signal Strength Tests
Flashing Number
Battery Level
1
Very Low
Low
2
3
Medium
4
High
Very High
5
Recycling and Desposal
The WEEE symbol means that this product and batteries must be disposed separately from other household
waste. When they reach their end of life, take them to a designated waste collection point in your area to
guarantee a safe disposal or recycling. Protect the environment, human health and natural resources!
Troubleshooting
False alarm is often caused by dust or steam.
After the batteries replacement, the device performs an auto-adjusting process in 8 hours period to establish its
operation. If false alarm happens within this period, it is important to clean the smoke alarm as described in
maintenance paragraph.
If a smoke alarm does not perform the "Remote Device Test", perform a "Factory Reset" and reinstall it on the
network. If it is far from neighboring smoke alarms, you may need to install an additional smoke alarm in
between.
If a smoke alarm receives a low signal level, place it closer to its nearest smoke alarm or install a new smoke
alarm in between.
Battery Replacement
1. Remove the smoke alarm the from mounting plate following Step 1 of the installation instructions.
2. Clean the device as described in maintenance paragraph.
3. Replace the old batteries by a new pair. Use recommended batteries for more reliable operation.
4. Place the smoke alarm on the mounting plate and secure it by turning it clockwise.
5. Test the correct operation of your smoke alarm as described in Device Test paragraph. If no sound is
generated, the smoke alarm must be replaced immediately!
4
Technical Characteristics
Sum of
Comments
POWER SUPPLY
Pressings
BATTERY LIFE
1
SMOKE CONCENTRATION SENSITIVITY
INDICATORS
1
ALARM SILENCE FACILITY
LOW BATTERY WARNING
Only on alarm mode
1
LOW BATTERY SILENCE FACILITY
1
Only on alarm mode
MOUNTING LOCATION
INTERCONNECTABLE
2
INTERCONNECTION CAPABILITY
OPERATIONAL FREQUENCY RANGE
2
TRANSMIT POWER
TRANSMISSION RANGE
3
DETECTION METHOD
DEGREES OF COVER PROTECTION
3
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIAL
Comments
EXTERNAL DIMENSION
The device operates
WEIGHT
None
normally
GUARANTEE
Device Under Testing
BS-506/WL
Wireless Interconnect
Smoke Detection
Battery Operated Smoke Alarm
EN 14604:2008, EN 300220-2
9 minutes
None
DoP: 921506002_59_001
reduced sensitivity
Exit from
None
alarm function
Replace the
batteries
Warranty
Replace the
smoke alarm
Olympia Electronics guarantees the quality, condition and operation of the goods.
The period of warranty is specified in the official catalogue of Olympia Electronics
and also in the technical leaflet, which accompanies each product. This warranty
Signal Strength
ceases to exist if the buyer does not follow the technical instructions included in
Very Weak
official documents given by Olympia Electronics or if the buyer modifies the goods
Weak
provided or has any repairs or re-setting done by a third party, unless Olympia
Medium
Strong
Electronics has fully agreed to them in writing. Products that have been damaged
Very Strong
can be returned to the premises of our company for repair or replacement, as long
as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods
and to or not charge the buyer depending on the reason of defection. Olympia
Electronics reserves the right to charge or not the buyer the transportation cost.
5
921506002_09_005
BS-506/WL
Replaceable batteries: 2x AA Lithium FR6 (L91)
10 years
0.110 dB/m
Optical and Acoustic > 85dB (A) at 3 m
Yes
Yes
Yes
Ceiling
Wireless
Up to 40 Smoke alarms
868-870 MHz
< 13,5 dBm
>100m in open area (LoS)
Optical
IP20
EN14604-2008, EN300220-2
o
0 to 45 C
Up to 93%
ABS/PC, PC
Ø1
30 x 43
mm
185gr.
3 years (1 year for the batteries)
1922
22
EGINIO
PIERIAS
60300
GREECE
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.com
info@olympia-electronics.gr
European
manufacturers
.
WIRELESS INTERCONNECT
BATTERY OPERATED
SMOKE ALARM
Battery
Life
IP20
Optical
10 years
85dB@3m
Thank you for your trust in our products
Olympia Electronics - European manufacturer
921506002_09_005
BS-506/WL
EN14604
EN
2008
300220-2

Advertisement

loading

Summary of Contents for Olympia BS-506/WL

  • Page 1 Very Low Very Weak official documents given by Olympia Electronics or if the buyer modifies the goods Weak provided or has any repairs or re-setting done by a third party, unless Olympia Medium Medium High Strong Electronics has fully agreed to them in writing.
  • Page 2 Wireless Link Test 3. With the button pressed, replace the battery you removed. The BS-506/WL provides wireless signal strength test with power level indication. First, perform the 4. Wait five seconds and release the button. The green led flash rapidly four times.