Every reasonable care has been taken during the writing of this manual. Please inform your local office if you find any inaccuracies or omissions. ACTi will not be held responsible for any typographical or technical errors and reserves the right to make changes to the product and manuals without prior notice.
This product complies with the European Low Voltage Directive 2014/35/EU and EMC Directive 2014/30/EU. WEEE Directive–2012/19/EU The product this manual refers to is covered by the Waste Electrical & Electronic Equipment (WEEE) Directive and must be disposed of in a responsible manner. www.acti.com...
Contact professionals for maintenance information. Do not attempt to dismantle the device by yourself. We shall not assume any responsibility for problems caused by unauthorized repair or maintenance. www.acti.com...
Page 6
Never look at the transmit laser while the power is on. Never look directly at the fiber ports and the fiber cable ends when they are powered on. Use of controls or adjustments to the performance or procedures other than those specified herein may result in hazardous laser emissions. www.acti.com...
Hardware Manual Introduction List of Models This hardware manual contains the following models: 2MP Outdoor Speed Dome with D/N, Adaptive IR, Extreme Z950 WDR, SLLS, 20x Zoom Lens www.acti.com...
Contact your local dealer if the package is damaged or incomplete. The attachments may vary with models, please see the actual model for details. Camera Power Adapter Quick Installation Guide Accessory Pack Bracket Adapter Ring Cable Gland Physical Description www.acti.com...
Please disconnect the power before mounting the camera. The camera does not provide power for external devices. Make sure to use external power source to power up external devices such as alarm input/output, audio, etc. For specifications, see the latest product datasheets. www.acti.com...
The cable connector needs to be crimped in position. When the cable connector is in position, ensure that the metal pieces of the cable connector are parallel to each other and the clamp of the cable connector is intact. www.acti.com...
4. Properly mount the waterproof ring in position. Mounting on the Wall 1. Mark the positions of the holes by referring to the mount points of the bracket and lead the cable through the hole on the wall. Then drill holes and knock the expansion bolts. www.acti.com...
Page 12
3. Attach the safety wire to the bracket and the dome. And Lead the tail cable through the bracket. 4. Attach the dome to the bracket adapter. Slide camera holders into inner track and turn camera till it is blocked by bracket adapter screw. Bracket adapter screw Inner track Camera holder www.acti.com...
Page 13
For waterproofing, apply sealant between the camera and the bracket, wall veneer slits, and leading-out holes of the wall. The above installation describes concealed installation. To implement open installation, directly lead the cable out from the cable slot on the bracket. www.acti.com...
Use self-adhesive waterproof tapes that will stick together with the twisted cables. Tighten waterproof tapes when wrapping the cables and make sure the cable connections are fully covered. You are recommended to put the waterproof cables in a waterproof junction box which needs to be purchased separately. www.acti.com...
Trusted sites, and then click Sites to add the website. If you use Windows 7, you need to save the setup.exe to your PC first, and then right-click the file, select Run as administrator, and then install it according to instructions. www.acti.com...
Need help?
Do you have a question about the Z950 and is the answer not in the manual?
Questions and answers