Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ACTi Z31
Summary of Contents for ACTi Z31
- Page 1 Mini Bullet Camera Hardware Manual 2017/07/20...
-
Page 2: Table Of Contents
Safety and Compliance Information ..........5 Introduction List of Models ..................7 Package Contents ................8 Physical Description ................ 8 Cable Connection ................8 Installation Procedures Wall Mount ..................9 Waterproof RJ-45 Connector ............10 Waterproof Tail Cable ..............11 Access the Camera www.acti.com... -
Page 3: Precautions
Every reasonable care has been taken during the writing of this manual. Please inform your local office if you find any inaccuracies or omissions. ACTi will not be held responsible for any typographical or technical errors and reserves the right to make changes to the product and manuals without prior notice. -
Page 4: Regulatory Compliance
This product complies with the European Low Voltage Directive 2014/35/EU and EMC Directive 2014/30/EU. WEEE Directive–2012/19/EU The product this manual refers to is covered by the Waste Electrical & Electronic Equipment (WEEE) Directive and must be disposed of in a responsible manner. www.acti.com... -
Page 5: Safety And Compliance Information
Contact professionals for maintenance information. Do not attempt to dismantle the device by yourself. We shall not assume any responsibility for problems caused by unauthorized repair or maintenance. www.acti.com... - Page 6 Never look at the transmit laser while the power is on. Never look directly at the fiber ports and the fiber cable ends when they are powered on. Use of controls or adjustments to the performance or procedures other than those specified herein may result in hazardous laser emissions. www.acti.com...
-
Page 7: Introduction
Hardware Manual Introduction List of Models This hardware manual contains the following models: 4MP Mini Bullet with D/N, Adaptive IR, Extreme WDR, SLLS, Fixed lens www.acti.com... -
Page 8: Package Contents
For specifications, see the latest product datasheets. Press and hold the RESET button for at least 15 seconds to restore factory default settings. Perform this operation within 10 minutes after the device is powered on or the reset will fail otherwise. www.acti.com... -
Page 9: Installation Procedures
3. Mount the plastic rivets of self-tapping 4. Screw the locknut to loosen the universal screws. joint before attaching your camera to the wall. Knock the plastic rivets into the guide holes and ensure that they are tightened up. Locknut www.acti.com... -
Page 10: Waterproof Rj-45 Connector
Ethernet interface and screw the waterproof bolt in. Insert in order NOTE: You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first. www.acti.com... -
Page 11: Waterproof Tail Cable
Use self adhesive waterproof tapes that will stick together with the twisted cables. Tighten waterproof tapes when wrapping the cables and make sure the cable connections are fully covered. You are recommended to put the waterproof cables in a waterproof junction box which needs to be purchased separately. www.acti.com... -
Page 12: Access The Camera
Trusted sites, and then click Sites to add the website. If you use Windows 7, you need to save the setup.exe to your PC first, and then right-click the file, select Run as administrator, and then install it according to instructions. www.acti.com... - Page 13 Copyright © 2017, ACTi Corporation All Rights Reserved 7F, No. 1, Alley 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu District, Taipei, Taiwan 114, R.O.C. TEL : +886-2-2656-2588 FAX : +886-2-2656-2599 Email: sales@acti.com...
Need help?
Do you have a question about the Z31 and is the answer not in the manual?
Questions and answers