Advertisement
3
Installing your appliance
3.1 Wall drilling and bracket
fixing
3.1.1 Wall mounting
Draw a vertical line on the at the center of the
wall.
From bench top (see A), drawing a horizontal line
(see B) above minimum installation height level.
Mark a reference point at C, Repeat this step on
the other side.
Drill ø 8mm holes at center of marking points.
Insert wall plug in the wall.
Fix the hood body to wall using 2 (ST5 x 25)
screw, tighten the screw firmly.
Note: Adjust the hood body alignment if neces-
sary.
Place mounting bracket on the wall at desired
height level, aligning bracket center at vertical
line (see D).
Cooker Hood / User Manual
Mark the center of the bracket holes and drill ø
8 mm holes. Insert wall plug in the wall. Secure
mounting bracket firmly using 2 (ST5 x 25)
screws.
Fix the inner duct to both mounting bracket
using 2 (M3x 12) screws.
Slide the outer duct downwards and ensure that
it is well seated on the hood body.
3.2 Aligning the hood body
Before attaching the hood body, adjust the two
screws located on the hood body mounting
points.
Hook the hood body onto the support screws
and tighten the support screws fully.
Adjust screws to level the hood body.
9 / 14 EN
Advertisement
