Toyota Supra 1997 Manual page 95

1 2 3 4 5 6 (Press buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in the
desired station (see "TUNE"). Push and
hold down the button until you hear a
beep-this will set the station to the button.
The button number will appear on the dis-
play.
To tune in to a preset station: Push the
button for the station you wantl. The but-
ton number and station frequency will ap-
pear on the display.
These systems can store one AM and one
FM station for each button. The preset
station memory will be canceled out if the
power source is interrupted (battery dis-
connected or fuse blown).
(Eject Button)
Push this button to eject a cassette.
After you turn the ignition to "LOCK", you
will be able to eject a cassette but you will
not be able to reinsert it.
96
WWW.MANUALS.WS
AM FM
Push "AM FM" to switch between the AM
and FM bands. "AM" or "FM" will appear
on the display.
If the audio system is off, you can turn on
the radio by pushing "AM
push the "AM FM" button to switch from
cassette operation to radio operation.
BAL (Balance)
This knob lets you adjust the balance be-
tween the right and left speakers.
Pull out "PWR/VOL/BAL". Turn the knob
to adjust the balance. Push the knob back
into its normal position.
BASS
This knob lets you adjust the bass level.
Push "BASS/TREB" so that it pops out of
its retracted position. Turn the knob to ad-
just the bass. Push the knob back into its
retracted position.
Dolby NR*
If you are listening to a tape that was re-
corded with Dolby
push the button marked with the
WWW.MANUALS.WS
double-D symbol. The double-D symbol
will appear on the display. Push the button
again to turn off Dolby NR.
The Dolby NR mode reduces tape noise
by about 10 dB. For best sound reproduc-
tion, play your tapes with this button on or
off according to the mode used for record-
ing the tape.
*: Dolby noise reduction manufactured under license from Dolby Lab-
FM". Also,
oratories Licensing Corporation. "DOLBY" and the double D symbol
are trademarks of Dolby Laboratories Licensing Corporation.
FADE
Move the "FADE" ring around "PWR/
VOL" to adjust the front/rear balance.
PROG (Program)
Push "PROG" to select the other side of
a cassette tape. The display indicates
which side is currently selected ( " " indi-
cates top side, " " indicates bottom side).
Auto-reverse feature—After the cassette
player reaches the end of a tape side, it
automatically reverses and begins to play
the other side. This is true whether the
cassette was playing or fast forwarding.
PWR/VOL (Power/Volume)
Push "PWR/VOL" to turn the audio sys-
tem on and off. Turn the "PWR/VOL" knob
to adjust the volume.
Noise Reduction,