Toyota Supra 1997 Manual page 61

On the filler panel behind the rear seat
With filler panel trim—
a. Using the illustration as a guide, run
your fingers across trim of the filler pan-
elitself to locate the position of the holes
underneath.
b. Make a hole in the covering directly
above the hole in the filler panel.
c. Insert a 10 mm (0.4 in.) spacer and
tighten down the anchor bracket for your
child restraint system with a bolt. Torque
the bolt to 16.5-24.7 N m (1.68-2.52 kgr-
m, 12.2-18.2 ft lf).
62
WWW.MANUALS.WS
Without filler panel trim—
a. Remove the cap on the filler panel
you wish to use.
b. Insert a 10 mm (0.4 in.) spacer and
tighten down the anchor bracket for your
child restraint system with a bolt. Torque
the bolt to 16.5—24.7 N m (1.68—2.52
kgf m, 12.2—18.2 ft lbf).
To comply with Canada Motor Vehicle
Safety Standards, vehicles sold in Cana-
da are provided with a bracket set in the
glovebox, designed for use with any of the
3 anchor locations shown in the illustra-
tion.
If your child restraint system does not pro-
vide any of the necessary parts, ask your
Toyota dealer. (See "—Child restraint sys-
tem".)
WWW.MANUALS.WS
Tilt steering wheel
To change the steering wheel angle,
pull up the lock release lever, tilt the
steering wheel to the desired angle
and release the lever.
CAUTION
!
D Do not adjust the steering wheel
while the vehicle is moving.
D After adjusting the steering wheel,
try moving it up and down to make
sure it is locked in position.