Table of Contents
Advertisement
5. Locate the memory module you want to replace. The memory modules are installed in the memory slots
on the system board. See "Parts on the system board" on page 34.
6. Remove any parts that might prevent your access to the memory module.
7. Open the retaining clips and gently pull the memory module out of the memory slot.
Figure 30. Removing a memory module
8. Position the new memory module over the appropriate memory slot. Ensure that the notch
memory module aligns correctly with the slot key
straight down into the slot until the retaining clips close.
Note: Ensure that you install memory modules following the installing sequence. Memory slot 1, or
memory slot 2 indicates the installing sequence. See "Parts on the system board" on page 34.
Figure 31. Installing a memory module
9. Reinstall the heat sink and fan assembly. See "Replacing the heat sink and fan assembly" on page 95.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 108.
Replacing a PCI Express card
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
100
Lenovo S500 Hardware Maintenance Manual
2
on the system board. Push the memory module
1
on the
Advertisement
Table of Contents
