Table of Contents
Advertisement
prevent difficult lighting and check that the
burner crown holes are not obstructed.
6.2 Periodic maintenance
Periodically speak your local Service
Force Centre to check the conditions of
7. TROUBLESHOOTING
You cannot start the ap-
pliance or operate it.
A sound operates when
the appliance is off.
The residual heat indica-
tor does not come on.
Heat setting alternates
A sound operates and
appliance starts and
stops again. After 5 sec-
onds one more sound
operates.
comes on
comes on
Problem
the gas supply pipe and the pressure ad-
juster, if fitted.
Possible cause and remedy
• You touched 2 or more sensor fields at the same
time. Only touch one sensor field.
• There is water or fat stains on the control panel.
Clean the control panel.
• Start the appliance again and set the heat setting in
10 seconds.
• The child safety device or key lock or Stop+Go op-
erates. See the chapter Operating the appliance.
You covered one or more sensor fields. Uncover the
sensor fields.
The cooking zone is not hot because it operated only
for a short time. If the cooking zone is supposed to
be hot, speak to the After Sales Service.
The Power management is active. See the section
Power management.
You covered
. Uncover the sensor field.
• The automatic switch-off operates. Stop the appli-
ance and start it again.
• Overheating protection for the cooking zone oper-
ates. Switch off the cooking zone. Switch on the
cooking zone again.
• No cookware on the cooking zone. Put cookware
on the cooking zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too
small for the cooking zone. Move cookware to a
smaller cooking zone.
ENGLISH
15
Advertisement
Table of Contents
