Rinnai Smart Cylinders ME13548830S Owner And Installer Manual page 20

Warranty terms and conditions continued
4. The warranty applies only to the components supplied by Rinnai. It does not apply to components
supplied by others, such as, but not limited to these, isolating valves, electrical switches, pipe work,
electrical cables, and fuses.
5. Where the cylinder has not been sited in accordance with the installation instructions or installed
such that normal service access is difficult, a service charge will apply. If at the discretion of the
attending service person the installation is deemed illegal or access is dangerous, service will be
refused. Any work required to gain reasonable access to the cylinder will be chargeable by the
attending service person (for example, removal of cupboards, doors, walls, or the use of special
equipment to move components, but not limited to these).
6. The cylinder warranty is for the period indicated in the summary table. Where the cylinder
and/or part is replaced under warranty the balance of the original warranty will remain effective.
7. Rinnai reserve the right to transfer functional components from defective water heaters if they are
suitable.
8. Rinnai reserve the right to have the installed product returned to the factory for inspection.
9. Where the cylinder is installed outside the metropolitan area or further than 40 km from a Rinnai
authorised service centre, travel costs shall be the owner's responsibility.
10. Rinnai reserves the right to replace the cylinder for another type if upon inspection it is deemed
another cylinder of a different construction is more suitable.
Warranty exclusions
The following exclusions may cause the warranty to become void and will result in a service charge and
costs of parts (if required).
1. Accidental damage and acts of God.
2. Failure due to abuse or misuse, improper maintenance or improper storage.
3. Failure due to incorrect or unauthorised installations.
4. Failure or damage caused by alterations, service or repair work carried out by persons other than
those authorised by Rinnai.
5. Where the cylinder has failed directly or indirectly as a result of poor water quality outside the limits
specified.
TDS (Total Dissolved Solids)
Up to 600 mg/L or ppm
6. Where it is found that there is no fault with the cylinder and the issue is related to the installation or is
due to power failure.
7. Subject to any statutory provisions to the contrary, Rinnai does not accept:
a. liability for consequential damage or any incidental expenses resulting from any breach of the
warranty.
b. claims for damage to building or any other consequential loss either directly or indirectly due to
leaks or any other faults.
20 | Rinnai Smart Cylinders MP indoor enamel: Owner & installer guide: 20431-D 04-17
Total Hardness CaCO Dissolved (free) CO
3
Up to 200 mg/L or ppm Up to 25 mg/L or ppm 6.5-8.5 Between -1.0-0.8
pH Langelier Index
2