Advertisement
Step 4
Install the front wheel
1. Remove the front fork plate with a 10mm wrench.
2. Put the e-bike on safe, flat ground. You can use the hard foam from the carton box to put on the
bottomof the fork to avoid damage caused by the friction between the front fork and the ground.
3. Prepare the wheels. There are two wheels hub protections on the two sides of the wheel. please rotate
andremove them.
4. Install the front wheel. Lift the front of the e-bike and put the wheel in the middle of the front fork. pay
attentionthat the brake rotor on the wheel and disc brake on front fork are on the same side. Install the front
wheel axle into the front fork fluted legs and ensure the brake rotor is smoothly placed in the disc brake.
5. Locate the quick release lever, which put into accessory box during shipment. Open the lever and remove the
thumb nut and one cone spring (opposite to the lever). Keep the washer and other cone spring in place on the lever
side.
6.
Install the lever into the front wheel axle. Insert from either side is OK. Next, re-install the cone spring pointing
towards the wheel hub, then thread the thumb nut onto the lever and turn tightly with lever open. Then close the
lever by hand without touching the brake rotor.
11
7. Attach the fender bracket to the front fork.
Use a 5mm Allen wrench to loosen the bolts of the front fender bracket hose clamp and fix the hose clamp to
the proper position of the front fork, make the clearance between the fender and tire evenly,be careful not to
install the wire harness into the hose clamp, Ensure the fender is centered and torque all mounting bolts to the
recommended torque value, 6 N m. (Refer to the table of Recommended Torque Value on pages 19)
8. When properly installed, the front wheel should be at the center of the front fork, the brake rotor should be
between the brake pads in the brake caliper, and the quick-release lever should be fully secured. Ensure that
the front wheel and quick release lever are properly secured before moving on to the next step.
NOTICE
· Never touch the brake rotor, especially when the wheel and/or bike is in motion, or serious injury could
occur.
· Hand oils can cause squeaking and decrease brake performance; do not touch the brake rotor while
inspecting, opening, or closing the quick-release lever.
12
Advertisement
