Advertisement
LCD Display Function Overview
The LCD display offers a variety of features to suit your
riding needs, including:
1.Battery level indicator
2.Pedal assist (PAS) level indicator
3.Speed (current speed, maximum speed, average speed)
4.Mileage display (single and total mileage)
5.Walk boost mode
6.Light ON/OFF
7.Error code indicator
8.Motor power indicator
9.USB connection indicator
10.Personalized parameter settings
11.Factory default parameter recovery function
The LCD display is equipped with five buttons on the corresponding operating unit:
power on/off
plus
minus
light
toggle
27
Routine Operation
1. Power on/off
Long press
to power on/off the display. When the display is off, it will not use the battery power
2. Display interface switching
When the display is powered on, it will show the Current Speed (km/h) and Trip Odometer (km) by default. Short
press
to switch between Trip Odometer, Odometer, Maximum Speed, and Average Speed.
3. Walk boost mode
Long Press and hold
, the electric bicycle enters the walk boost mode. The electric bicycle will walk at a fixed
speed of 6 km/h and the display shows
. Release
state before walk boost.
The walk boost mode can only be used when pushing the electric bicycle, please do not use it while riding.
4. Turning on/off lights
Press the
to make the controller turn on the lights and the display backlight becomes dim. Press
make the controller turn off the lights and the backlight restore brightness.
5. PAS level selection
Press
/
to switch PAS level of electric bicycle, thus changing the motor output power.
6. Battery level display
The Battery level is shown as 5 bars. When the battery is full charged, all of the 5 bars lighten up. When the
battery is fully depleted, the bar will begin to flash, warning the user to charge the battery as soon as possible.
to stop the power output immediately and restore to the
again to
28
Advertisement
