Table of Contents
Advertisement
4100 Insert ACC
E. Surround & Trim Kit Installation
1. Lay surround face down on a protected surface to
prevent scratching.
2. Using a Phillips head screw driver attach the side
surrounds to the top surround using 2 #8 sheet metal
screws provided with the kit (Figure 20.1).
3. Lay the trim face down and place the corner brackets
into position.
4. Using a standard flat screw driver tighten the corner
brackets (Figure 20.2).
5. Slide the trim over the surround set.
6. Install the surround set and trim set to the outer can.
Place the hook in the surround sides over the surround
attachment screws, 2 on each side (Figure 20.3).
7. Place top on top of appliance.
Secure 2 Side Surrounds to
Figure 20.1
Corner Brackets
Figure 20.2
STOVE TOP
Figure 20.3
20
Top Surround
F. Blower Cord Installation on Left Side
The blower cord is shipped on the right side of the
appliance. You may relocate the cord so it is on the left
side.
Relocating Blower Cord to Left Side
1. Remove the convection blower housing from the
appliance by removing two 5/32 allen head bolts.
2. Remove Blower assembly from appliance by removing
two 8/32 phillips head screws located under ashlip
(Figure 20.4).
3. Using phillips head screw driver, remove snap disc
bracket and cord restraint bracket from right side
(Figure 20.5).
4. Re-install snap disc bracket and cord restraint bracket
to left side of blower housing (Figure 20.5).
5. Re-install blower housing and blower assembly in
reverse order.
Blower Assembly
5/32 Allen Bolts
(x2)
Blower Housing
Figure 20.4
SURROUND
ATTACH POINTS
Figure 20.5
7045-910I
8/32 screws
(x2)
January 10, 2020
Advertisement
Table of Contents
