Table of Contents
Advertisement
3. Remove the four 3/8" x 2 3/4" Screws (22)
from the Uprights (83). Save the Screws.
4. Set the Uprights (83) on the Base (74). Make
sure that the hole with the Upright Wire (75)
is on the right side.
Attach the right Upright (83) to the Base (74)
with two of the 3/8" x 2 3/4" Screws (22) and
two of the 3/8" x 3 1/4" Screws (18) that you just
removed and four 3/8" Star Washers (3); do not
fully tighten the Screws yet. Make sure that
the Base Wire (52) is not pinched.
Attach the left Upright (not shown) in the
same way. Note: There is not a wire on the
left side. Fully tighten the four 3/8" x 2 3/4"
Screws (22) and the four 3/8" x 3 1/4" Screws
(18).
3
22
4
83
3
10
83
18
3
3
75
3
52
74
22
22
Advertisement
Table of Contents
