Troubleshooting Guide - DeWalt D25911 Manual

English
For assistance with your product, visit our website at www.dewalt.com for a list of service centres.
PROBlEM
Tool will not start.
Reduced power.
The chisel cannot be released.
10

TROUBLESHOOTING GUIDE

BE sURE TO FOllOW sAFETY RUlEs AnD insTRUCTiOns
POssiBlE CAUsE
The extension cord and/or plug is defective.
Internal components are too hot.
The extension cord is too long and/or its gauge
is inadequate.
The voltage provided by the electric supply is inadequate.
The chuck is not pulled back fully.
sOlUTiOn
Have the extension cord and/or plug checked by a qualified
electrician and replaced if necessary.
Allow tool to cool down.
Use an extension cord of an approved length and/or of
adequate gauge.
Connect the hammer to an adequate electric supply.
Pull the chuck back as far as it will go and remove the chisel. Refer
to Inserting and Removing SDS max® Accessories.