Table of Contents
Advertisement
USE AND OPERATION (CONTINUED)
Button Functions (continued)
To check if the tracker is powered on and online, press the power button once.
The blue LED light will flash once if the tracker is active.
To send an SOS message to your App, press and hold the power button for 3 seconds
until the large yellow light starts flashing to indicate the message has been sent.
To reset the tracker to factory settings, connect it to your plugged in Router / Charging
Dock (the Tracker must be connected to the Router to reset properly), press and hold
the power button for 30s until the yellow light stops flashing. The tracker will beep
when the reset has begun, please wait 2 minutes for the device to fully reset. After
resetting, the Tracker will be deleted by the App. The Tracker's blue light will flash
continuously when ready to be reconnected again.
To reset the tracker router, connect the router (with GPS attached) to a power
outlet for 2-3 seconds and then unplug it for 2-3 seconds. Repeat this 5 times
to complete the reset.
*Resetting your tracker and router will remove it from your Honeywell Smart Pet App
account. Do this only if your tracker has been unable to access the internet
or if you want to change ownership of your tracker. Resetting your tracker will
not reset your tracker subscription plan.
Light Indicators
Small Blue Light:
Power On Indication - light flashes 2 times.
App Pairing Mode Indication - light flashes rapidly and continuously.
Successful Pairing Indication - rapid blinking and then the light turns off.
Tracker Online Indication - light blinks once.
Charging In Progress Indication - the light turns green while connected
to the Router / Charging Dock.
EN
7
Advertisement
Table of Contents
