Digital Audio Input/Output Ratings; Control Input/Output Ratings; Other Input And Output Specifications; Recorder/Player Specifications - Tascam Sonicview 16 Owner's Manual

MONITOR OUT L/R jacks
Connectors: XLR-3-32 equivalent (1: GND, 2: HOT, 3: COLD)
Maximum output level: +24 dBu
Nominal output level: +4 dBu
Output impedance: 100 Ω or less
Phones jack
Connectors: 6.3mm (1/4") stereo phone jack,
3.5mm (1/8") stereo mini jack
Maximum output: 100 mW + 100 mW (32Ω load, when
connected to only one jack)

Digital audio input/output ratings

Dante PRIMARY/SECONDARY connectors
Connector: etherCON Cat5e compatible connector*
Transmission protocol: Dante
Gigabit Ethernet standard: 1000BASE-T (IEEE 802.3ab)
Cables: category 5e or faster STP cables
* etherCON is a registered trademark of Neutrik AG.
USB Audio
Sampling Rate: 48 kHz, 96 kHz
Bit Depth: 32 bit
Number of inputs: 32 channels (Input to this unit)
Number of outputs: 32 channels (Output from this unit)

Control input/output ratings

FOOTSWITCH jack
Connector: 6.3mm (1/4") TS phone jack
(Tip: HOT, Sleeve: GND)
ETHERNET connector
Connector: RJ-45
Compatible standards: 100BASE-TX, 1000BASE-T
GPIO connector
Connector: 25-pin D-sub (8-in/8-out, female, inch-standard)
i See "GPIO settings" on page 34 for details about the
GPIO connector and assignments.

Other input and output specifications

USB port (Top panel)
Connector: USB Type-C
Protocol: USB 2.0 HIGH SPEED (480 Mbps)
USB port (Rear panel)
Connector: USB Type-B
Protocol: USB 2.0 HIGH SPEED (480 Mbps)
LAMP jack
Connector: XLR 4-pin female (pin 4: +12V, pin 3: GND)
Power supply voltage: 0 V – +12 V
Maximum output: 5 W
WORD IN connector
Connector: BNC
Input level: 0.5–5 Vp-p
Input impedance: 75 Ω ±10% (termination resistance on)*
Input frequency: 48, 96 kHz
Allowable frequency deviation: ±100 ppm
* See "Setting the master clock and word connectors" on
page 32 for details about turning termination resistance
on/off.
WORD THRU/OUT connector*
Connector: BNC
Output level: equivalent to 5V TTL
Output frequency: 48, 96 kHz
* See "Setting the master clock and word connectors"
on page 32 for details about through/word output
switching.

Recorder/Player specifications

Recording media
SDHC cards (8GB–32GB, Class 10 or more)
SDXC cards (64GB–128GB, Class 10 or more)
USB flash drives (8GB–128GB, playback only)
NOTE
A list of SD cards that have been confirmed for use with this
unit can be found on our web site. Access this list from the
product page of this product on the TEAC Global Site (https://
teac-global.com) or contact the TASCAM customer support
service.
File System
SDHC card: FAT32
SDXC card: exFAT
USB flash drives: FAT32/exFAT
Recording/playback formats
BWF/WAV
Recording: 48/96 kHz, 24-bit, 2-channel
Playback: 48/96 kHz, 16/24-bit, 2-channel
MP3
Playback: 44.1/48 kHz, 32–320 kbps, 2-channel
AAC
Playback: 44.1/48 kHz, 64–320 kbps, 2-channel
TASCAM Sonicview 16/Sonicview 24
41