–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
below.
–
Place handlebar supports in required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
K00620-10
Screw, handle-
bar support
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
or bent.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamp.
–
Mount screws
–
First bolt the handlebar clamp with screws
higher side of the handlebar supports so that both parts touch.
–
Tighten screws
Guideline
Screw, handlebar
clamp
3
. Take off the handlebar clamp. Remove
4
. Take off handlebar supports
6
and push through nuts
4
.
M10
40 Nm (29.5 lbf ft)
3
, but do not tighten yet.
3
evenly.
M8
20 Nm (14.8 lbf ft)
SETUP 2
5
.
7
from
Loctite
®
243™
3
onto the longer,
5