ETC F-Drive FD-RPS-48-1000 Installation Manual

ETC Installation Guide
F-Drive Power Supply
Introduction
Congratulations on your purchase of the ETC F-Drive Power Supply. The F-Drive Power Supply
houses a single power supply and is compatible with an F-Drive R12 LED driver.
F-Drive System Design Tool
Visit the F-Drive System Design Tool (etcconnect.com/FDriveSysDesignTool) to design an F-Drive
R12 system with different luminaires, breakout boxes, cable lengths, and other system
components.
Compatible Products
F-Drive Power Supply is compatible with the F-Drive R12 enclosure with up to 12 output cards.
Documentation for Compatible Products
The following documents are available at
Drive/Documentation.aspx:
• F-Drive Power Supply Datasheet
• F-Drive R12 Datasheet
• F-Drive Series R12 Installation Manual
• F-Drive R12 and W1 Wiring Reference Guide
Safety
The F-Drive Power Supply is intended for professional use only. Read the entire manual before
using this equipment.
This equipment is not suitable for use in locations where children are likely to be present.
Label Symbols
Power Supply Drivers are conveniently labeled with relevant symbols for your safety. Refer to the
product label to see which symbols apply to your product.
General warning
This product should not be discarded as unsorted
waste but must be sent to separate collection facilities
for recovery and recycling.
The product input or output is suitable for direct
current only.
The product input or output is suitable for alternating
current only.
Safety extra low voltage device
Protective earth (ground)
Corporate Headquarters n Middleton, WI, USA | +1 608 831 4116
Global Offices n London, UK | Rome, IT | Holzkirchen, DE | Paris, FR | Hong Kong | Dubai, UAE | Singapore
New York, NY | Orlando, FL | Los Angeles, CA | Austin, TX | © 2023 Electronic Theatre Controls, Inc.
Web
Trademark and patent info:
Product information and specifications subject to change. ETC intends this document to be provided in its entirety.
7148M2140 Rev A Released 2023-06
etcconnect.com | Support support.etcconnect.com
etcconnect.com/ip
etcconnect.com/Products/Power-Controls/LED-Drivers/F-
Avertissement général
Ce produit ne doit pas être jeté avec les déchets
ménagers mais doit être déposé dans une collecte de
déchets électroniques ou dans un point de collecte.
L'entrée et la sortie de ce produit convient uniquement
au courant continu.
L'entrée et la sortie de ce produit convient uniquement
au courant alternatif.
Dispositif de sécurité à très basse tension
Protection Classe I Mise à la terre
| Contact etcconnect.com/contactETC
| Third-party license agreement info: etcconnect.com/licenses