Table of Contents
Advertisement
If your product has two gas outlets;
• One of the two outlets is sealed with a
blind plug. The end of the other outlet is
open.
1
Gas hose outlet
2
Blind plug
(The outlet to which the blind plug is
attached may vary depending on the
product model.)
• Before gas connection, make sure that
the natural gas valve and the gas hose
outlet of the product to be connected to
the gas is on the same side.
• If the natural gas valve and the open-
ended gas hose outlet are on the same
side, make the gas connection as shown
in the figure below.
• If the natural gas valve and the gas hose
outlet sealed with the blind plug face on
the same side, remove the blind plug
from the gas hose outlet using two
wrenches. Close the gas hose outlet with
this blind plug where gas connection will
not be made with a new (unused) sealing
gasket.
• Make the gas connection as shown in the
figure below on the gas hose outlet near
the natural gas valve.
Seal all connections with gas sealant.
1. Shut gas supply.
2. Connect safety (gas) hose
valve of the oven.
3. Connect gas hose with elbow joint
1
Gasket
2
Adapter (optional) with 1/2" outlet
3
Gas (safety) hose
4
Valve with 90° outlet
5
Connection piece
6
Gas supply pipe
Risk of fire:
If you do not make the connection
according to the instructions below, there
will be the risk of gas leakage and leak. Our
company cannot be held responsible for
damages resulting from this.
•
Gas connection must be made by the
authorised service provider only.
•
Gas connection of the product must
definitely be made through the gas
hose outlet near the LPG cylinder.
•
Plastic plug must be disposed, and the
gas hose outlet that will not be used
must be sealed with the blind plug.
3
to the inlet
4
.
21/EN
Advertisement
Table of Contents
