Table of Contents
Advertisement
6. After completing the wire connections,
close the terminal block cover.
7. Route the power cable so that it will not
contact the product and get squeezed
between the product and the wall.
Power cable must not be longer
than 2 m because of safety
reasons.
Gas connection
DANGER:
Product can be connected to gas
supply system only by an authorised
and qualified person or technician
with licence.
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held
responsible for damages arising
from procedures carried out by
unauthorised or unlicensed persons.
DANGER:
Before starting any work on the gas
installation, disconnect the gas
supply.
There is the risk of explosion!
•
Gas adjustment conditions and values
are stated on labels (or ion type label).
•
In the UK, Gas Safe registered
installers (Including the Regions of
British Gas) undertake to work to safe
and satisfactory standards.
Regulations
The cooker must be installed in accordance
with the Gas Safety (Installation and Use)
Regulations and the relevant Building
Regulations in force.
Your product is equipped for natural
gas (NG).
The cooker is designed for UK
installation using a flexible connection
with tubing in accordance with the
regulations in force. Length of 900mm
is recommend.
Make sure that the natural gas valve is
readily accessible.
Service Representative will remove the
plug during connection and connect
your appliance by means of a straight
connection device (coupling).
If a flexible hose is used it must not come
into contact with the top 150mm/6 inches
(hot region) of the rear of the appliance. Do
20/EN
not pass the hose through the (**) hot
region behind the oven.
(**)
Hot region
If you need to use your appliance
later with a different type of gas, you
must consult an authorised service
centre for the related conversion
procedure.
If your product has only one gas outlet;
• Before connecting the gas hose, make
sure that the gas hose outlet at the back
of the product is on the same side of the
product as the natural gas valve.
• If the gas hose outlet and the natural gas
valve do not face the same side, make sure
that the hose does not pass through the hot
area when connecting it.
Advertisement
Table of Contents
