Samsung SyncMaster 152B User Manual page 16

Troubleshooting
Check List
Symptom Check List
The screen shows Is the screen displaying only one
strange colors or color as if looking at the screen
just black and white. through a cellophane paper?
Have the screen colors become
strange after running a program
or due to a crash between
applications?
Has the video card been set
properly?
The screen is out of focus or Have you adjusted the resolution or
OSD cannot be adjusted. frequency on the monitor?
LED is blinking but no images Is the frequency properly adjusted
on the screen. when checking the Display Timing
on the menu?
There are only 16 colors Have the Windows colors been
shown on the screen. set properly?
The screen colors have
changed after changing the
video card.
Has the video card been set
properly?
There is a message that reads Have you installed the monitor
"Unrecognized monitor, driver?
Plug & Play (VESA DDC)
See the video card manual to see
monitor found".
if the Plug & Play (VESA DDC)
function can be supported.
28
Solution
Check the signal cable connection.
Make sure the video card is fully
inserted in it's slot.
Reboot the computer.
Set the video card by referring to the
video card manual.
Adjust the resolution and frequency of
the video card.
Adjust the frequency properly by
referring to the video card manual.
(The maximum frequency per
resolution may differ from product to
product.)
For Windows ME/XP/2000:
Set the colors properly at the Control
Panel, Display, Settings.
Set the video card by referring to the
video card manual.
Install the monitor driver according to
the Driver Installation Instructions.
Install the monitor driver according to
the Driver Installation Instructions.
Specifications
General
Model Name SyncMaster 152B
LCD Panel
Size 15.0 inch diagonal
Display area 304.1 (H) x 228.1 (V)
Pixel Pitch 0.297 (H) x 0.297 (V)
Type a-si TFT active matrix
Viewing Angle 80/80/70/80(L/R/T/B)
Synchronization
30 ~ 61 kHz
Horizontal
56 ~ 75 Hz
Vertical
Display Color
16,194,277 Colors
Resolution
Optimum resolution 1024 x 768@60Hz
Maximum resolution 1024 x 768@75Hz
Input Signal, Terminated
RGB Analog, 0.7 Vpp positive at 75 ohms Separate H/V sync, TTL level positive or negative
Maximum Pixel Clock
80 MHz
Power Supply
AC 90 ~ 264 VAC, 60/50 Hz ± 3Hz
Signal Cable
15pin-to-15pin D-sub cable, detachable
Power Consumption
Max. 31W
Dimensions (WxDxH) / Weight
357.5 X 184.5 X 346.7mm (After installing of Stand) / 2.9kg (With Bagic Stand)
357.5 X 50.7 X 288.5mm (After folding the stand) / 3.1kg (Multimedia Stand)
VESA Mounting Interface
75mm x 75mm (for use with Specialty(Arm) Mounting hardware.)
Environmental considerations
Operating Temperature: 50°F ~ 104°F(10°C ~ 40°C) Humidity: 10% ~ 80%, non-condensing
Storage Temperature: -4°F ~113°F (-20°C ~ 45°C) Humidity: 5% ~ 95%, non-condensing
Dot Acceptable
TFT LCD panel manufactured by using advanced semiconductor technology with precision of 99.999% above is
used for this product. But the pixels of RED, GREEN, BLUE and WHITE color seem to be bright sometimes or
some of black pixels could be seen. This is not from bad quality and you can use it without uneasiness.
For example, the no. of TFT LCD pixels that is contained in this product are 2,359,296.
Plug and Play Capability
This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and
computer systems will provide the best operating conditions and monitor settings. In most cases,
monitor installation will proceed automatically, unless the user wishes to select alternate settings.
Note Design and specifications are subject to change without prior notice.
29