CONFIDENTIAL 1 Precautions Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as electrical shock. 1-1 Safety Precautions 1-1-1 Warnings For continued safety, do not attempt to modify the (READING SHOULD circuit board. NOT BE ABOVE 0.5mA) Disconnect the AC power and DC Power Jack before servicing.
CONFIDENTIAL 3 Disassembly and Reassembly This section of the service manual describes the disassembly and reassembly procedures for the MO17P*/MO17E* monitors. WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling these components. 3-1 Disassembly Cautions:1. Disconnect the monitor from the power source before disassembly. 2.
CONFIDENTIAL 4 Troubleshooting Notes: 1. Before troubleshooting, setup the PC’s display as below. • Resolution: 1280 x 1024 • H-frequency: 64 kHz • V-frequency: 60 Hz 2. If no picture appears, make sure the power cord is correctly connected. 3. Check the following circuits. •...
CONFIDENTIAL 8 Wiring Diagram CN402 INVERTER CN101 BRT_ADJ BRIGHT BL_ON/OFF BKLT_EN MAIN PCB +14V DC +14V DC +14V DC +14V DC +14V DC +14V DC CN202 CN601 MO17P*/MO17E*...
Page 35
CONFIDENTIAL 6 Electrical Parts List Loc. No. Code No. Description Specification Remarks BH68-00329C LABEL BAR CODE -,ALL,TCO99,DOMESTIC,ART-PAPER 90G,-,WHT,BLACK,-,-,- BH75-10529C UNIT-HANDLE/PACKING S/M170MP,PE-LD,PE-HD,-,WHITE,- BN72-60001A LEVER TOP LSD210TL,PE-LD,WHITE,TFT_LCD BN72-60002C LEVER BOTTOM S/M170MP,PE-HD,BLUE BN69-00371A S/M172B,W/W,CB-SW4,WHT,OFFSET,A-1,L473*W399*H122 BN92-00555A ASSY LABEL MO17ES BN68-00310B LABEL RATING MO17ES,EDC,SYNC,PE,T0.05,90,45,PE NATURE,SILVER/GUNMETAL BN92-00556A ASSY ACCESSORY MO17ES...
Page 36
CONFIDENTIAL 5 Exploded View & Parts List Memo MO17P*/MO17E*...
Page 37
CONFIDENTIAL 4 Troubleshooting 4-2-1 No Video [Analog] Check signal cable and connection. Does the video signal appear at the Pin 48, 47, 46, 45, 42, 41, 40, 39, 38, and 37 of IC401? Is Pin 2(BKLT_EN) of IC203 High? Check TFT-LCD panel and Inverter. Check IC301 and related circuit.
CONFIDENTIAL 4 Troubleshooting 4-2-2 No Video [Digital] Check signal cable and connection. Does the video signal appear at the Pin 48, 47, 46, 45, 42, 41, 40, 39, 38, and 37of IC401? Is Pin 2(BKLT_EN) of IC203 High? Check TFT-LCD panel and Inverter. Check IC301 and related circuit.
Page 40
CONFIDENTIAL 3 Disassembly and Reassembly 4. Remove 2 screws on the hinge mounting. Do not remove the screw for cable clamp. 5. Disconnect the stand cable from socket and remove stand assembly. 6. Remove 2 screws of cover rear. 7. Open the cover rear by using opening jig.
Page 41
CONFIDENTIAL 3 Disassembly and Reassembly 9. Seperate shield ass’y and panel ass’y. 10. Remove screws on main board and inverter board. MO17P*/MO17E*...
Page 42
CONFIDENTIAL 3 Disassembly and Reassembly 3-2 Replacement Order of Lamp Assemblies 1. After confirm there is nothing on the disk Turn the LCD module over and put it on a flat desk set to the ground. 2. Push down the stopper and slide the lamp unit.
Page 43
CONFIDENTIAL 3 Disassembly and Reassembly 4. Please fix the new lamp units on the LCD module : opposite process 2 and 3 Replacement of lamp unit should be done at the power off state and recommanded clean bench condition. 3-3 Reassembly Reassembly procedures are in the reverse order of Disassembly procedures.
Page 44
CONFIDENTIAL 3 Disassembly and Reassembly Memo MO17P*/MO17E*...
CONFIDENTIAL 2 Product Specifications 2-2 Pin Assignments Sync 15-Pin D-Sub Signal Cable Connector Type Separate Composite Sync-on-green Pin No. Red video Red video Green video Green video Green video + H/V Sync. Blue video Blue video Blue video GND (DDC Return) GND (DDC Return) GND (DDC Return) Red video GND...
Page 46
CONFIDENTIAL 2 Product Specifications 2-3 Timing Chart This section of the service manual describes the timing that the computer industry recognizes as standard for computer-generated video signals. 2-3-1 LCD Panel Mode : 1 mode Definition of Terms "Activer"Video Blanking Video Back Top/Left "Addressable"Video...
CONFIDENTIAL 1 Precautions 1-2 Servicing Precautions WARNING: An electrolytic capacitor installed with the wrong polarity might explode. Caution: Before servicing units covered by this service manual, read and follow the Safety Precautions section of this manual. Note: If unforeseen circumstances create conflict between the following servicing precautions and any of the safety precautions, always follow the safety precautions.
Page 53
Samsung Electronics Co.,Ltd. 416, Maetan-3Dong, Paldal-Gu, Suwon City, Kyungki-Do, Korea. Printed in Korea P/N : BN82-00074A-00 http://www.samsungmonitor.com (SyncMaster Worldwide) http://www.samsung-monitor.com (SyncMaster USA) http://www.sec.co.kr/monitor (Korea)