Door Control - Craftsman 139.54985 Owner's Manual

Features (Continued)
USING YOUR GARAGE DOOR OPENER
The garage door opener can be activated through a wall-mounted
door control, remote control, wireless keyless entry or
AssureLink™ accessory.
When the door is closed and the garage door opener is activated
the door will open. If the door senses an obstruction or is
interrupted while opening the door will stop. When the door is in
any position other than closed and the garage door opener is
activated the door will close. If the garage door opener senses an
obstruction while closing, the door will reverse. If the obstruction

Door Control

SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press
the push bar until the garage door opener activates (it may take up
to 3 presses). Test the door control by pressing the push bar, each
press of the push bar will activate the garage door opener.
USING THE DOOR CONTROL
Command LED
NOTE: If the command LED is
continuously blinking, the Lock
Push Bar
feature needs to be deactivated.
PUSH BAR
Press the push bar to open or close the door.
LOCK
The LOCK feature is designed to prevent activation of the garage
door opener from remote controls while still allowing activation
from the door control and keyless entry. This feature is useful for
added peace of mind when the home is empty (i.e. vacation).
Activate:
Press and hold the LOCK button for 2 seconds. The command LED
will flash as long as the lock feature is activated and your hand held
remote control will not operate your door at this time.
Deactivate:
Press and hold the LOCK button again for 2 seconds. The command
LED will stop flashing and normal operation will resume.
LEARN
Button
LOCK
Button
LIGHT
Button
interrupts the sensor beam the garage door opener lights will
blink 10 times. However, you can close the door if you hold the
button on the door control or keyless entry until the door is fully
closed. The safety reversing sensors do no effect the opening
cycle.
The safety reversing sensor must be connected and aligned
correctly before the garage door opener will move in the down
direction.
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, or
AssureLink™ accessories can be programmed to the garage
door opener by pressing the Learn button on the Multi-Function
Control Panel.
LIGHT
Press the LIGHT button to turn the garage door opener lights on
or off. When the lights are turned on they will stay on until the
LIGHT button is pressed again, or until the garage door opener
is activated. Once the garage door opener is activated the lights
will turn off after the specified period of time (the factory setting
is 4-1/2 minutes). The LIGHT button will not control the lights
when the door is in motion.
To change the amount of time the garage door opener
lights will stay on:
Press and hold the LOCK button until the garage door opener
lights flash.* The time interval is indicated by the number of
flashes.
NUMBER OF TIMES GARAGE
DOOR OPENER LIGHTS FLASH
1
2
3
4
To cycle through the time intervals repeat the step above.
LIGHT FEATURE
This feature will turn on the garage door opener lights when the
safety reversing sensors have been broken.
Deactivate:
Press and hold the LIGHT button until the garage door opener
lights turn on, then off again.*
Activate:
Start with the garage door opener lights on. Press and hold the
LIGHT button until the garage door opener lights turn off, then
on again.*
* Approximately 10 seconds
32
TIME THE GARAGE DOOR
OPENER LIGHT STAYS ON
1 ½ Minutes
2 ½ Minutes
3 ½ Minutes
4 ½ Minutes