Connecting To External Components; Connecting The Fm, Am Antennas - Samsung MM-KC10 Instruction Manual

Connecting to External Components

Connecting to an External Analog Component
Example: Analog signal components such as a VCR, Camcorder, and TV.
1
Connect Audio In on the DVD player to Audio Out on the external analog component.
•
Be sure to match connector colors.
2
Press AUX to select AUX.
•
' AUX' appears in the display.
13
Audio Cable
If the external analog
component has only one
Audio Out, connect either left
or right.

Connecting the FM, AM Antennas

FM Antenna (supplied)
FM antenna connection
1. Connect the FM antenna supplied to the
FM 75Ω COAXIAL terminal.
2. Slowly move the antenna wire around until
you find a location where reception is good,
then fasten it to a wall or other rigid surface.
If AM reception is poor, connect an
outdoor AM antenna(not supplied).
AM Loop Antenna
(supplied)
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
AM antenna connection
1. Connect the AM loop antenna supplied
to the AM and terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
14