Table of Contents
Advertisement
Deciding How to Connect DVD-VCR
GB
You must take into account various factors when connecting audio or video systems:
N Types of connectors available on your systems
N Systems connected permanently to the DVD-VCR (satellite receiver for example) or
temporarily (camcorder for example)
Your DVD-VCR is equipped with the following connectors.
Connector
Location
Type
LINE
Rear
Audio/Video RCA
COMPONENT Rear
RCA
output
S-VIDEO
Rear
S-JACK
output
OUT TO TV
Rear
75
coaxial
IN FROM ANT. Rear
75
coaxial
☛
Whenever you connect an audio or video system to your DVD-VCR, ensure that all
elements are switched off.
Refer to the documentation supplied with your equipment for detailed connection
instructions and associated safety precautions.
10
Direction
Recommended Use
N Television
In/Out
N Other VCR
N COMPONENT out (DVD only)
Out
N S-Video out (DVD only)
Out
N Television
Out
N Aerial
In
N Cable television network
N Satellite receiver
Connecting DVD-VCR to the TV using the Coaxial Cable
To receive television programmes a signal must be received from
one of the following sources:
N An outdoor aerial
N An indoor aerial
N A cable television network
N A satellite receiver
☛
Make sure that both the television and the DVD-VCR are
switched off before connecting the cables.
1
Remove the aerial or network input cable from the television.
2
Connect this cable to the 75 coaxial socket marked
rear of your DVD-VCR.
3
Plug the coaxial cable supplied into the
socket on your
DVD-VCR.
4
Plug the other end of the coaxial cable into the connector
previously used for the aerial on the television.
5
To obtain better quality pictures and sound on your television, you
can also connect your DVD-VCR to the television via the RCA
cable (see section below) if your television is equipped with this
type of connection.
Connecting DVD-VCR to the TV using the RCA Cable
TV
3
RF coaxial cable
You can connect your DVD-VCR to the television using the RCA cable if the appropriate input is available
on the television. You thus:
N Obtain better quality sound and pictures
N Simplify the setting up procedure of your DVD-VCR
☛
N Regardless of the type of connection chosen, you must always connect the coaxial cable supplied.
Otherwise, no picture will be visible on the screen when the DVD-VCR is switched off.
N Make sure that both the television and the DVD-VCR are switched off before connecting the cables.
1
Connect the coaxial cable as indicated in the above section.
2
Connect one end of the RCA Audio/Video cable to the Video output and Audio L, R output socket on the rear
of the DVD-VCR.
3
Plug the other end into the appropriate connector on the television.
GB
2
on the
TV
4
3
Aerial
2
11
Advertisement
Table of Contents
