Sapho KTX-C User Manual page 65

KTX-B
Heating element heats the radiator that it is installed in and, at the
same time, controls its temperature. For temperature regulation
please use buttons and . LCD display panel shows current tem-
perature measured inside the radiator. After settings have been mod-
ified, display panel will flash showing the newly set temperature for
a few seconds and will go back to displaying current temperature.
Heating indicator will come up on the display panel if the newly
set temperature is higher than the current one. In order to see the
set temperature, press one of the arrows on the display.
EN
time settings (clock/dryer/timer)
on/off button
parameters regulation
active 24-hour timer
timer active zone code
clock
temperature
heating indicator
Construction of the device as well as physical characteristics of the
heating agent inside the radiator influence the way in which the heat
is distributed — the temperature of the bottom pipes of the radiator
(especially the two located at the very bottom of the radiator) may
be lower than the temperature of the remaining parts of the radia-
tor — this is a normal phenomenon.
Turning the device on does not mean that it uses the same maximum
power for the whole time it is on. On turning the device on, it op
User Manual — Electric Heating Element
65