Mani Palmyra MIR-1017 Owner's Manual page 4

(7)Press the SELECT button;
(8) Turn the dial until your appropriate equipment;
A u t o
W i r e d O n l y
W i r e l e s s O n l y
If you select Auto, it will be select automatically.
If you select Wired Only, It will be only used for Wired Ethernet.
If you select Wireless Only, It will be only used for Wireless Wi-Fi connection.
(9) When the ESSID for the access point you want to connect to be displayed on the
screen, press the SELECT button. You might need to enter the correct WEP (Wired
quivalent Privacy) or WPA(Wi-Fi Protected Access) code .
If your network is not configured to need a WEP or a WPA code, the display will show:
N e t w o r k O K
If the screen displays:
Encryption Key Required
Then the network is using one of the encryption systems:
Wired Equivalent Privacy (WEP) or Wi-Fi protected Access (WPA). You therefore
need to enter the correct WEP or WPA code into the radio for it to communicate with
your network.
After 3seconds the display goes into the code entry mode or press SELECT.
T o enter the code, use the dial to select each character of the code in turn, pressing the
SELECT button after each character.
Make sure the character you want is shown in the centre of the display to be able to
select it.
WEP and WPA codes are case sensitive to upper and lower case characters so you
must enter them exactly.
After the final character, use the dial to select END and press the SELECT key.
~
< { }
END < >0
-3-