Table of Contents
Advertisement
Configure Menu
Choosing the option you want from the Configure Menu
1.Press the SELECT button.
(Note: If you make a mistake at any point ,press BACK button to go back
to the previous screen.)
2.Turn the knob until 'Configure' is displayed
3.Press the SELECT button.
4.Turn the knob until the display shows the option you want.
5.Press the SELECT button to choose the option shown on the display. The options are
explained below.
<Network Config>
Enables you to configure your radio's network settings, scan again for a connection to
another wireless network, or to manually configure the network parameters. This is
useful if you take the Internet radio to
another building where you want to use.
<Version>
Displays the versions numbers of the various parts of software the hardware on you
Internet radio.
<Upgrade Firmware>
Use this option to download new firmware for the radio from the Reciva portal on the
internet. If there is new firmware available, the radio will prompt you if you want to
download it or not. Note, at this stage, you can press the radio's BACK button to cancel
the radio beginning a firmware upgrade. A firmware upgrade may take several minutes, so
do no switch off the power to the radio until the operation is complete otherwise the radio
may become permanently damaged.
<Language>
Allows you to change the display language.
<Factory Reset>
Puts all the setting back to their default as they were when they left the factory. If you
perform a factory reset on your radio you will loss all you presets and your wireless
network connection.
<Register>
This will display a key that can be used to register the radio on the Reciva Customer
portal.
<Clock>
Use this option to set the time, to set an alarm and to view the current alarm setting,
see'' Setting the clock'', ''Setting the alarm''.
<Sleep Timer>
Selecting this option will enable the Internet radio to switch itself off after a set period.
-14-
Advertisement
Table of Contents
