Table of Contents
Advertisement
3
Installation
Refer to the nearest Authorised Service Agent for
installation of your product.
C
Preparation of location and electrical installation for
the product is under customer's responsibility.
B
Installation and electrical connections must be
carried out by a qualified personnel.
A
Prior to installation, visually check if the product
has any defects on it. If so, do not have it installed.
Damaged products will cause risks for your safety.
Appropriate installation location
• Install the product in an environment which has no
risk of freezing and is in a stable and level position.
• Operate your product in a well ventilated, dust-free
environment.
• Do not block the air ducts in front of and under the
product with materials such as long pile rugs and
cupboard plinths.
• Do not place your product on a long pile rug or on
similar surfaces.
• Do not install the product behind a door with a lock,
sliding door or a hinged door which can strike the
product.
• Once the product is installed, it should stay at the
same place where its connections have been made.
When installing the product, make sure that the rear
wall of it does not touch anywhere (tap, socket, etc.)
and also pay attention to install the product at a
place where it will stay permanently.
B
Do not place the product on top of the power cable.
• Keep at least 1.5 cm distance to walls of other
furniture.
Ventilation hose and connection (for
products equipped with an outlet vent)
Ventilation hose assures exhausting of the air from
inside the machine.
Vented dryer has 1 air outlet.
Stainless sheet metal or aluminum pipes can be used
instead of the hose. The diameter of the pipe to be used
should be minimum 10 cm.
Maximum hose and pipe lengths are given in the table
below.
Maximum length
1 elbow 45°
1 elbow 90°
1 elbow 90° short
1 wall passage
C
Each elbow and other passages should be
subtracted from the above maximum length.
To connect a ventilation hose;
Hose
Pipe
4 m
5 m
-1.0 m
-0.3 m
-1.8 m
-0.6 m
-2.7 m
-2.0 m
-2.0 m
1. Connect the air outlet hose to the hose spacer piece
by turning it anti-clockwise.
2. Make the hose passages as shown below.
C
Exhaust of humid air from the dryer into the room
is inconvenient. It may damage the walls and furniture
in the room.
C
The ventilation hose can be routed outdoors via a
window or it can be connected to an air outlet in the wall
(see diagram below).
C
Air outlet hose must be extended directly to the
outdoors. There must be a small number of elbows as
not to hinder air ventilation.
C
To prevent water accumulation in the hose, make
sure that it is not folded on the floor.
B
The air ventilation hose should not be connected to
the chimney of a stove or a fireplace.
B
Do not operate your machine at the same time
with heaters such as a coal or gas stove. Airflow may
cause the chimney to flare up.
Adjusting feet
In order to ensure that your product operates more
silently and vibration-free, it must stand level and
balanced on its feet. Front feet of your product can be
adjusted. Balance the machine by adjusting the feet.
1. Loosen the feet by hand.
2. Adjust the feet until the product stands level and
firmly on the floor.
C
Do not use any tools to loosen the adjustable feet,
otherwise, they can be damaged.
C
Never remove the adjustable feet from their
housings.
8
EN
Advertisement
Table of Contents
