Solution Suggestions For Problems - Beko DVTC710W Installation & Operating Instructions And Drying Guidance

Vented time dryer
Table of Contents

Advertisement

9

Solution suggestions for problems

Problem
Drying process takes
The filter might have not been cleaned.
too much time.
* The filter might have not been cleaned.
Laundry comes out wet
* Excessive laundry might have been loaded
at the end of drying.
in.
* It might have not been plugged in.
* The loading door may be ajar.
Machine does not
* Programme might have not been set or the
switch on or the
«Start/Pause/Cancel» button might have not
programme does not
been pressed.
start. Machine is not
* «Childproof lock» might have been activated.
activated when set.
* The condenser cover on the models with a
condenser might not be closed securely.
Programme has been
* The loading door may be ajar.
interrupted without any
* Electricity may be cut off.
cause.
Laundry has shrunk,
* A programme suitable for the laundry type
become felted or
might have not been used.
deteriorated.
Drum light does not
* The machine might have not been started by
come on.
using the On/Off button.
(for models equipped
* Bulb may have blown.
with a lamp)
* The 2-hour anti creasing programme to
0 / Anti-creasing" LED
prevent laundry from creasing might have
flashes.
been activated.
0/ Anti-creasing" LED
* Programme has come to an end.
is on.
"Filter cleaning" LED
* Filter might have not been cleaned.
flashes.
A
Call an authorised service agent if the problem persists.
Cause
Explanation / Suggestion
* Meshes of the filter may be clogged. Wash with
water.
* Meshes of the filter may be clogged. Wash with
water.
* Do not overload the machine.
* Make sure that the machine is plugged in.
* Make sure that the loading door is properly closed.
* Make sure that the programme has been set and it
is not in "Pause" mode.
* Deactivate the childproof lock.
* Make sure that the condenser cover and the red
lock is closed securely.
* Make sure that the loading door is properly closed.
* Press «Start/Pause/Cancel» button to start the
programme.
* Dry only the laundry which is suitable for drying
in your machine after checking the labels on your
clothes.
* Select a programme with suitable low temperature
for the laundry type to dry your clothes.
* Make sure that the machine is On.
* Call the authorized service to replace the bulb.
* Turn off the machine and take out the laundry.
* Turn off the machine and take out the laundry.
* Clean the cover filter.
20
EN

Advertisement

Table of Contents
loading

Table of Contents