Barco SLM R6 Executive Owner's Manual page 23

Connections
Input module insertion into the projector
To insert a module in one of the free slots, handle as follow :
1 Power down the projector and disconnect the power cord from the wall outlet.
2 Remove the dummy plate covering the chosen input slot by turning out both screws.
3 Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.
4 Press on both handles of the input module until the module plug seats in the connector of the projector.
5 Secure the input module by tightening both retaining screws.
6 Reconnect the power cord to the wall outlet and switch on the projector.
The new installed module can be selected with the digit buttons on the RCU or the local keypad.
U‚Ðh ’
uh…qv…rq
…r€ ‚‡r
8US GÃ"
2Q
S
CvtuÃ7hq vq‡uÃÃ$Ã867G@ÃDIQVU
S
CvtuÃ7hqvq‡uÃÃ$Ã867G@ÃDIQVU
All manuals and user guides at all-guides.com
9 vht‚†‡vpÃ8 ‚qr DSS rp rv‰r…
B…rrÃPƒr…h‡v‚
S rqÃT ‡hqi’
Ch…qv…rq
…r€ ‚‡r
8USGÃ!
T’pÃPF DS
Ch…qv…rq
…r€ ‚‡r ST!"!#!!ÃPVU 8PHHÃQPSU
S T!"! #!! ÃDI
8USGÃ

P VU DI Ã  
DI Ã
 

P
T9DÃ9DB DU6G ÃDIQ VU
C9ÃT9DÃ9DBDU6 GÃHP9VG@
C8 W
B 7
9WDÃDIQVU
C8 W
B 7
9WDÃDIQVU
USDB B@SÃP VU
P V U 
 
 

5
9WDÃPVUQVU