Installing The Monitor; Operation; Pairing Process - Voyager WVSXM70CV User Manual

I
NSTALLING THE
1. Plug power cable into the back of the monitor.
2. Attach the suction cup mount to the rear of the monitor with the supplied bracket.
3. Locate a flatter section of glass on your windshield (that does not block your vision)
and apply suction cup (as shown in diagram). Snap the lever on the suction cup
mount into the locked position.
4. Connect the power cord to a 12 Volt DC outlet.
5. Align the antenna to its upright position, parallel to the monitor.
O
PERATION
1. Turn on the vehicle's Accessory Power and press the power button on the monitor.
2. In the top left corner of the monitor, you will see the signal strength meter.
3. Adjust the suction cup bracket to provide the best viewing angle.
P P
AIRING ROCESS
This system contains an Auto-Pairing function. If your monitor is not receiving a signal from
the camera; the two may not be paired correctly.
1. Make sure the monitor is connected to 12 Volt DC power supply, but 12 Volt DC power is
removed from the camera (clearance lights turned off).
2. Press the SEL/PAIR button on the front of the monitor expected mode & select the
appropriate AV source.
3. Press and hold the "SEL/PAIR" button on the front of the monitor for 5 seconds and
release. (Monitor will display "PAIRING")
4. Apply 12 Volt DC power to the camera (turn on the clearance lights). If pairing multiple
cameras to the system, make sure that only the only the corresponding camera
(Camera 1 –Camera 4 corresponding to Monitor's CH1- CH4) has power when pairing.
If done correctly, the monitor will display "PAIRING SUCCESSFUL". If pairing is not
successful, the monitor will display "PAIRING FAIL". If you receive this message, repeat steps
3-4.
M
ONITOR
EN-2