Advertisement
WIRING
This unit is designed to operate on 12V DC. Link-up with the camera is achieved via customer provided standard stranded
cable such as SOOW. The cable video/power drop cable can be routed either through the mounting surface or through a
cable guide on the edge of the mounting base.
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
where weatherproofing may be required. Universal voltage driver permits operation at 12V DC.
Warning: Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram
Secure each pair of wires according to the diagram. Utilize a junction box or
similar
device
and
connections if installed in a location where water may come in contact with the
unit. Ensure the unit is properly grounded and that wiring is done according to
all local and national electrical/building codes.
Low Voltage DC
Connect power to power supply outputting low voltage at 12 Volts DC. This variable voltage allows greater versatility
without affecting light output. Ensure deutsch connectors are properly connected (If applicable).
MOUNTING
The EXPCMR-ALG-HDSD-1080P-12VDC explosion proof security camera is secured to flat surface, such as a ceiling or
wall, using and adjustable reverse pedestal style bracket. The included mounting bracket allows 90° vertical adjustment and
360° of swivel for precision aiming.
MAINTENANCE
Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool down before
performing maintenance.
Warning: No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens will void
the warranty.
1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine
checks to be made on a yearly basis. Frequency of use and environment should determine this. It is
recommended to follow an Electrical Preventive Maintenance Program as described in NFPA 70B:
Recommended practice for Electrical Equipment.
2. The lens should be cleaned periodically as needed to ensure continued photometric performance.
Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid
cleaner.
3. Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or
contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.
4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
Larson Electronics, LLC
take
precautionary
steps
Phone: (800) 369-6671
, in all locations especially in outdoor areas
for
weatherproofing
all
Fax: (903) 498-3364
EXPCMR-ALG-HDSD-1080P-12VDC
www.larsonelectronics.com
2 of 3
Advertisement
